Master Planning & Feasibility
Throughput basis, tankage sizing, plot development and phasing — a design basis the owner can take to investors and regulators before committing capital.
A fuel terminal is a machine for moving product safely at the lowest cost per ton. Every design decision — receipt hydraulics, tankage configuration, pump selection, loading architecture, automation depth — either adds to or subtracts from that economics for the life of the asset.
This practice designs terminals from both sides of the fence: years spent operating a Mediterranean fuel terminal (300,000+ tons/year throughput) before three decades of designing them. That operating history shows in the details — like the gravity-assisted loading system at IPT Terminal that cut the operation's power consumption and maintenance cost by roughly 70%.
Throughput basis, tankage sizing, plot development and phasing — a design basis the owner can take to investors and regulators before committing capital.
Marine and pipeline receipt, sea-line interfaces, manifold design and pump station engineering sized for the real operating profile rather than nameplate flow.
Loading rack architecture, metering, overfill protection, earthing and vapor handling — including gravity-assisted designs that strip power and maintenance cost out of dispatch.
Storm-water and hazardous-product drainage with properly engineered API separators — including closed-circuit, zero-air-emission designs purpose-built for environmental compliance.
Control room design, control narratives, custody-transfer metering and the instrumentation architecture that lets a small operations team run a large terminal.
Construction sequencing that keeps the terminal receiving and dispatching through the works — demolition, tie-ins and commissioning planned around operations, not instead of them.
Engagements run project-based (defined scope and deliverables), as a standing technical advisory retainer, or start small with a fixed-scope audit — see engagement models.
Yes — that is the normal case, not the exception. The five-year IPT renovation kept the terminal in commercial operation throughout, and the fast-track Jirco rehabilitation was sequenced so commissioning began while the tail of the works was still closing out.
Conventional pumped loading carries three permanent costs: power, pump maintenance and transfer-safety exposure. Where site elevation and tankage allow it, a gravity-assisted design removes most of all three — at IPT it cut overall operations power consumption and maintenance cost by approximately 70%.
Yes. Six years of operations and maintenance responsibility for the EDL Zouk power-station sea lines (700,000+ tons/year discharged) plus terminal-side receipt design experience — including SBM moorings, flexible hoses, MOVs and cathodic protection.
From the commercial operating profile: vessel or pipeline receipt parcels, product slate, dispatch pattern and growth assumptions. Tankage, pumping and loading capacity are then sized against that profile with hydraulic calculations — not rules of thumb — so capital goes where throughput actually needs it.
A short description of your facility and challenge is enough to start. You'll get a discovery call invitation and an initial qualification questionnaire — available worldwide.