Detailed Engineering Design
Multidisciplinary design package for the drying oven optimization and automation scope.
Engineering study and automation of a painted steel plate drying oven during transitory operating periods — controlling thermal exchanges to cut disqualified product by 90 % and lift yearly production by about 5 %.
Case study published 18 May 2026 · Last reviewed 9 June 2026
Multidisciplinary design package for the drying oven optimization and automation scope.
Thermal balance and transient analysis of the drying unit to derive the control philosophy.
Automation logic and instrumentation specification controlling thermal exchanges during transient regimes.
Coordination with Stein Heurtey and FFM operations to fit the new control scheme to existing process equipment.
The solution centred on closing the loop around the oven's thermal exchanges during transient regimes. Process sensing was reorganised to capture the variables that actually drive plate quality, automation logic was specified to actively manage heat input against measured product conditions, and the control philosophy was tuned so that the oven self-stabilises through start-up, throughput changes and recipe transitions — rather than relying on operator-side adjustments that lag the process.
Out-of-specification painted plate production during transitory periods cut by 90 % through tight control of thermal exchanges in the drying unit.
Recovered transitory-period output lifted the plant's annual production by approximately 5 % — a direct commercial return on the study.
Lower energy consumption while holding consistent product quality across operating regimes.
Automation absorbs transient management — operators focus on supervision rather than constant manual correction.
Send the brief — Eng. Naim replies personally with a discovery-call invitation and a short qualification questionnaire.